The Belkin router reset process reverts your router’s settings to the factory default settings. All of the modified or customized configurations of your Belkin router are erased when you reset Belkin router. Here are some of the scenarios that may be applicable for router reset.
- Setting up your Belkin router after an unsuccessful attempt
- Can’t access the web interface or web-based management page due to lost password
- Can’t access the internet even after updating the Belkin router firmware
- Reconfiguring the Belkin router after it stopped working properly
- PC or mobile can’t get a valid IP from your Belkin router
So these were some of the main scenarios in which you will be required to go about the Belkin router reset process. Furthermore, there are two methods through which you can reset your device. We will discuss both methods to reset Belkin router in this post.
Method 1: Belkin Router Reset using a Button
In this method, you need to use the reset button of your router. Kindly follow the steps very carefully;
- Firstly, the Belkin router should be in active mode.
- Locate the reset button and press it.
- Make sure you hold the reset button for good 15 seconds and then release it.
- After that, your wireless router will take a few minutes to revert to the factory default settings.
- Once the router reboots, it means the new settings are applied to your router.
Method 2: Reset Belkin Router via the Web Browser
This process is performed on your computer. Firstly, ensure that your PC is connected to the router’s network. After that, follow the steps outlined below;
- Open a web browser on your PC and type the Belkin router IP address.
- Type 192.168.2.1 in the address bar and press Enter.
- The browser will direct you to the router’s web-based setup page.
- Click Login and then enter the Belkin router login credentials.
- Once you are logged into the router, you will see the web management page.
- Thereafter, click Restore Factory Defaults under Utilities.
- After that, click Restore Defaults and the power LED of the router will blink for a few seconds.
- Finally, the Belkin router reset process will be initiated. It will take a few minutes for your router to restore the factory default settings on your device.
NOTE: For the second method, make sure you know the login credentials of your wireless router. The login credentials include the username and password of your router.
Bottom line
This post was all about the Belkin router reset process using the two most widely used methods. Although we discussed both methods, the most used method is the reset method. We also suggest that you use the first method to send your router back to its default factory settings. We hope that this post was useful to you and that it helped you learn how to reset to the factory defaults.